From: Fernanda – IST Sistemas [mailto:[email protected]]
Sent: Friday, May 17, 2013 7:41 PM
To: Eddie Pevzner; Natalie Somekh
Subject: IST demonstrated the Power of iMachining at Iscar Die & Mold Workshop in Brazil
Hello SolidCAM Team,
I’m writing to tell you how was the Iscar WorkShop about Die & Mold in Brazil, last week.
We had almost 70 participants from Die & Mold Companies.
It was our first experience cutting with iMachining – it was very important to see and feel iMachining.
During the presentation one part was cut with iMachining. Everybody was impressed with the Power of iMachining.
Our next steps is to train Sandro (ISCAR technical guy) on SolidCAM and iMachining, with the target to hold an iMachining Workshop at Iscar Training Center.
Attached are some pictures. At this event we were with Willian, Ricardo, Valdir and Fernanda.
SolidCAM and IST Team… Thank you so much for the collaboration.
Best Regards,
Fernanda Marzola
Departamento Comercial
[email protected]
Skype: fernanda_marzola